Wiki: Hygrometers

HTC-1 Brand Combination Digital Hygrometer, Thermometer, Alarm Clock - CheeseForum.org

Honeywell brand model TM005X digital Hygrometer - Thermometer with wireless remote sensor, different readings due to different response speed from opening fridge door to take picture. Note poor mat material selection and surface stress cracks on 1 lb cheese after rapid surface dehydration in very low humdity kitchen fridge - CheeseForum.org
Honeywell brand model TM005X digital Hygrometer - Thermometer with wireless remote sensor, different readings due to different response speed from opening fridge door to take picture. Note poor mat material selection and surface stress cracks on 1 lb cheese after rapid surface dehydration in very low humdity kitchen fridge - CheeseForum.org
This Wiki Article discusses Hygrometers which are used to measure humidity levels in air ranging from 0% to 100% relative humidity, abbreviated RH. This article is divided into the following sections:

Uses

  • Humdity is not an issue in coagulation or cheese forming stages or for fresh unaged cheeses but is a key parameter for the aging phase, for cheeses that are aged.
  • Most aged cheeses after air drying are are initially aged with a natural rind or partially sealed rind i.e. by oiling the rind and then either continued aging in that fashion or sealed with wax or vaccuum bags for longer term aging. During the natural or partially sealed aging, if the humidity is excessive, unwanted molds can result on cheese surfaces, conversely, too low a humidity can result in unwanted dehydration of the cheese. Extreme low humidity, for young moist cheeses, will rapidly dehydrate their surfaces resulting in surface cracks or fissures from the uneven dehydration of the cheese.
  • Thus accurate humidity levels are critical, old cheese makers can sense the aging environment’s humidity level based on experience, for new cheese makers it is recommended that a Hygrometer be used.

Back to top

Nexxtech Brand Digital Hygrometer-Thermometer With Wired Thermometer Only Remote - CheeseForum.org
Nexxtech Brand Digital Hygrometer-Thermometer With Wired Thermometer Only Remote - CheeseForum.org

Preferred Requirements

  • Small if small cave, to minimize space consumption.
  • Accurate at high humidity.
  • Does not corrode at very high humidities.
  • Includes a thermometer as temperature is another important parameter in the art of affinage.
  • Can be calibrated for both humidity and temperature.
  • Remote readout if small cave such as a small refigerators as opening the door to take a meausurement can result in rapid humidity and temperature changes before the hygrometer – thermometer stabilizes resulting an incorrect readings.

Back to top

Availability

Hygrometers are available from Cheese, Wine and beer making supply stores, hardware type stores, and large supply stores like Wal-Mart, Tesco’s, Amazon, or eBay. If buying in physical store (versus from webstore) and for digital units if working, compare units to choose the one with the average reading which is probably best initialy calibrated.

HTC-1 Brand Combination Digital Hygrometer, Thermometer, Alarm Clock - CheeseForum.org
HTC-1 Brand Combination Digital Hygrometer, Thermometer, Alarm Clock - CheeseForum.org

Back to top

Wiki: Air Drying

Food grade plastic mats with capilliary forces holding water between threads resulting in poor air drying of bottom's of cheeses.

This article discusses air drying which entails drying the freshly formed cheese ia evaporation to air to remove excess moisture from the surface and thereby form a dehydrated rind that can better withstand unwanted molds and yeasts. Note, pressed cheeses include those that are pressed with an external weight or if large via their own internal weight, also some such as washed curd Gouda types are brined after pressing before being air-dried. 

For hobby and small commercial cheese makers, air drying is performed by placing the young cheese(s) on a mat at room temperature typically for 2-3 days such that moisture is evaporated into the air is enable and the cheese is periodically turned to maintain it’s shape and enable even drying of all sides. Commercially, this phase is accelerated by cold air being blown on the young cheeses. 

Note, removal of a small amount of water from the cheese naturally results in similar small amount of shrinkage. 

Air Drying Method

1 pound cheese, surface initiated fissures after 3 days improper air drying in 37 F very low humidity kitchen fridge.
1 pound cheese, surface initiated fissures after 3 days improper air drying in 37 F very low humidity kitchen fridge.

The primary problem is to obtain the right speed and amount of drying, the variables being cheese size and moisture content, and air humidity, movement and temperature. 

Not enough evaporation and the cheese’s surface will stay moist and be a base for molds and yeasts. Conversely too fast will result in uneven moisture content across the cheese, the outer rind will dehydrate rapidly resulting in shrinkage while the middle stays moist and does not shrink. This results in tension stress around the surface and compression in the middle of the cheese, somewhat similar to a football but on a much smaller stress scale. 

The problem here is that cheese has very poor tensile strength and if this stress is excessive, dried too quickly, then the cheese will split in one or several places to relieve the stress. This splits will often result in deep fissure type defects as the moister middle of the cheese has even less tensile strength than the dehydrated surface. An example common environment causing this problem is air drying in household kitchen cold and low humidity fridge, even if in a higher humidity vegetable or cheese drawer. Solutions to this splitting are discussed in the Wiki: Defects articles. 

Air Drying Base

Food grade plastic mats with capilliary forces holding water between threads resulting in poor air drying of bottom's of cheeses.
Food grade plastic mats with capillary forces holding water between threads resulting in poor air drying of bottom's of cheeses.

A second common problem is how to enable the base or bottom side of cheese to dry. 

Placing cheeses on an impermeable surface such as plastic or china plates is the worst as the bottom will stay completely wet and whey as it is expelled will puddle, resulting in a severe location for molds and yeasts to start. 

At the other extreme, drying cheeses on widely spaced metal racks will result in the best circulation of air and thus drying of the bottom of the cheese, but depending on cheese hardness and wire spacing will often result in less aesthetically pleasing deep deformation “dent” lines in the young soft cheese. 

In between these two extremes are cloth and mats. Cloth and closely spaced mats also do not work well, while they let the cheese breath, capillary forces will often hold water in the mesh, a location for molds and yeast. Mats if close spaced weave will also do the same, see samples in picture at right where only the right widely spaced “thread count” mat avoids this problem and is recommended, but only when placed on a wire rack to allow good air flow beneath it. Placing a cheese on any mat on an impermeable plate will still pool whey. 

Air Drying Time & Temperature

2 kg Gouda with oil-pepper-cocoa rind, blue mold on bottom resulting from poor mat selection and poor air ventilation below mat as on impermeable surface.
2 kg Gouda with oil-pepper-cocoa rind, blue mold on bottom resulting from poor mat selection and poor air ventilation below mat as on impermeable surface.

Air drying is completed when the whey completely stops draining and the cheese’s surface is dry. At what length of time and temperature is a more difficult discussion given the range of sizes and moisture contents of cheese, and range of air temperatures and humidity levels. 

That said, normal recipe air drying time before aging to obtain a good dry rind is 1-3 days at average house temperatures of 72°F/21°C and ~70-75% humidity, assuming minimal air movement, i.e. not in front of an open window or fan. 

Temperatures above and below that will require less or more air drying time than the recipe. If room temperatures are significantly above that (ie summer or if in tropics) then best to air dry in fridge but then have to be very sensitive to rapid drying of rind from low humidity and cracking of rind, ie turn twice per day and inspect for cracks. 

Higher humidity levels significantly above 75% will require longer time, below 60% may result in cracking as described above and thus the cheese should be partially enclosed to obtain an optimum humidity level, such as by covering the cheese with a loose fitting bowl.