CheeseForum.org » Forum
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
This topic
This board
Entire forum
Home
Help
Login
Register
CheeseForum.org » Forum
»
GENERAL CHEESE MAKING BOARDS (Specific Cheese Making in Boards above)
»
Problems - Questions - Problems - Questions?
»
Removing Inner Plastic Ring from Form
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: Removing Inner Plastic Ring from Form (Read 1029 times)
Milk Maid
Guest
Removing Inner Plastic Ring from Form
«
on:
July 20, 2013, 04:31:39 PM »
Does anyone have advice on how to remove the inner ring of a plastic specialty pressed cheese form such as this one for Manchego (
http://www.fromagex.com/usa/english/moulds/pressed/manchego-mould-o-110mm-1296
)?
Teeth, pliers, oil drops and swear words aren't working.
Logged
linuxboy
Guest
Re: Removing Inner Plastic Ring from Form
«
Reply #1 on:
July 20, 2013, 05:13:49 PM »
It just slides out IIRC. Invert, rubber mallet tap, finish?
Logged
jwalker
Guest
Re: Removing Inner Plastic Ring from Form
«
Reply #2 on:
July 24, 2013, 12:53:45 PM »
Did you try immersing in hot water , as a mechanic , I use Heat all the time for pulling tight bearings or bushings from shafts or inner bosses.
You never know , it might work on plastic as well.
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
CheeseForum.org » Forum
»
GENERAL CHEESE MAKING BOARDS (Specific Cheese Making in Boards above)
»
Problems - Questions - Problems - Questions?
»
Removing Inner Plastic Ring from Form