CheeseForum.org » Forum
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
This topic
This board
Entire forum
Home
Help
Login
Register
CheeseForum.org » Forum
»
GENERAL CHEESE MAKING BOARDS (Specific Cheese Making in Boards above)
»
EQUIPMENT - Forming Cheese
»
best way to Kadova molds
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: best way to Kadova molds (Read 2274 times)
Chris_Abrahamson
Guest
best way to Kadova molds
«
on:
April 04, 2012, 03:58:54 PM »
Hello all
I could use some direction on the best way to clean Kadova molds. There is a general thread from two years ago that discusses using a caustic/lye wash followed by an acid rinse but it was rather vague.
Doesn't anyone have any specific directions including source recommendations for any special chemicals if needed.
Thanks for the help
Chris
Logged
linuxboy
Guest
Re: best way to Kadova molds
«
Reply #1 on:
April 04, 2012, 04:17:11 PM »
http://www.cvm.umn.edu/dairy/prod/groups/cvm/@pub/@cvm/documents/asset/cvm_33550.pdf
Logged
Chris_Abrahamson
Guest
Re: best way to Kadova molds
«
Reply #2 on:
April 05, 2012, 03:11:28 PM »
Thanks - this was very helpful. I finally got around to using the molds I got from you last year. Just wanted to know the best way to clean them.
Logged
linuxboy
Guest
Re: best way to Kadova molds
«
Reply #3 on:
April 05, 2012, 03:16:18 PM »
A suggested approach is to clean in an alkaline detergent to remove solids, and then rinse in some type of sanitizing solution. You can use any type of cleaners available... such as oxyclean and then dip in bleach. You don't need to use lye.
Logged
FRANCOIS
Guest
Re: best way to Kadova molds
«
Reply #4 on:
April 05, 2012, 11:07:24 PM »
The best way to clean Kadovas is to bring them down to the beach and drop kick them as far as you can into the ocean.
Logged
linuxboy
Guest
Re: best way to Kadova molds
«
Reply #5 on:
April 06, 2012, 12:19:16 AM »
lolerskates. Sure it's not by using a trebuchet?
Logged
george
Guest
Re: best way to Kadova molds
«
Reply #6 on:
April 06, 2012, 11:18:25 AM »
Quote from: linuxboy on April 06, 2012, 12:19:16 AM
lolerskates. Sure it's not by using a trebuchet?
Made from Legos.
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
CheeseForum.org » Forum
»
GENERAL CHEESE MAKING BOARDS (Specific Cheese Making in Boards above)
»
EQUIPMENT - Forming Cheese
»
best way to Kadova molds