CheeseForum.org ยป Forum
GENERAL CHEESE MAKING BOARDS (Specific Cheese Making in Boards above) => STANDARD METHODS - Making Cheese, Coagulation => Topic started by: Clean break on February 27, 2013, 03:34:45 PM
-
Hello All,
I have been adjusting my rennet amounts after a few batches of gouda and cheddar that flocced at 6-7 minutes. I lowered by a third and got no floc after 40 minutes while trying to make a tomme (obviously too much adjusting ::)) I am getting milk direct from the farm but from several different sources at this point until I settle in to one farm for cow and one for goat and sometimes I mix in some store bought milk to stretch my dollars. Eventually I will get a feel for how each milk acts since I am taking copious notes.
My question is what should I do if I ad too little rennet and the milk does not set? Keep waiting? Add something? Turn it into something else?
I really don't want to waste any batches.
Thanks,
Scott
-
The only answer I have for that is to wait longer for the set.....the longest flocc time I have ever had experience with was about 20 minutes (after I made an over-adjustment).
Since I use liquid rennet, I started counting drops. I determined that 24 drops was approximately 1/4 of a tsp, and that 24 drops resulted in, normally, about a 15 minute flocculation for 2 gallons of the milk I use.
Switching suppliers will affect how much rennet is needed quite possibly.
How much rennet are you using for how much milk?
-
OK counting drops puts it in perspective. I really like that idea.
I have been using 1/2 t. for 2 gallons as per the recipes. I am just starting out so I do not have that many batches to compare but the last three have been made using the flocc. method and they all were at 6-7 min. so I cut back a third on the rennet which was clearly too much of an adjustment. I also must admit I could have been off by many many drops given the amount of attention I have been giving to the level of the measuring spoons. Now that I think about it there is quite a few drops difference between a little under full and a bulging spoon.
It sure seems like it is better over all to have a little too much rennet than too little then adjust down slightly the next batch. I have sourced some local jersey milk as well as swiss cow milk from a fellow cheese maker nearby as well as some really good goat milk from a farm just down the road. This farm fresh stuff sets so much better than the store bought stuff I started out using I can't even believe it.
I like the idea of counting drops.
I still wonder what to do to rescue the batch if I do not get any floc action after like 30 minutes or so. Fromage blanc? add more rennet, get it to set and ....???
Thanks for the reply
Scott