CheeseForum.org ยป Forum

CHEESE TYPE BOARDS (for Cheese Lovers and Cheese Makers) => FRESH LACTIC ACID COAGULATED - Normally Whey Removed => Topic started by: Vaudevilleorange on July 15, 2011, 07:28:36 PM

Title: Chevre Moulds - Size/Shape/Holes Recommendations
Post by: Vaudevilleorange on July 15, 2011, 07:28:36 PM
I am going to be trying my first true chevre cheese...I added cultured buttermilk at 74 degrees, it is ripening right now, I am waiting for the pH to drop a bit, down to 7.0...it started out at 7.5 - as soon as that pH is reached I am going to add .5 drop of rennet (two gallons of milk being used)

Then I am going to incubate it at 72 degrees for 24 hours...or until the pH reaches 4.4-4.6, THEN I will ladle the curds into a mold.

Now, here is my true question...can I use a hard cheese mold to drain the cheese?

Specifically THIS mold http://cdn.nexternal.com/hombre/images/Hard_Cheese_Mold_800g_L.jpg (http://cdn.nexternal.com/hombre/images/Hard_Cheese_Mold_800g_L.jpg)

Or are there too many holes? Would I get too much air drying thus a not as creamy chev? OR would it work?

Any input on the mold or my cheese process please comment away! Thanks!
Title: Re: Chevre Moulds - Size/Shape/Holes Recommendations
Post by: george13 on July 15, 2011, 11:48:19 PM
I would tend to use a mold with fewer holes for chevre, precisely as you stated to preserve its creaminess.  I noticed that your starting pH was above 7, is that normal for raw milk?  Also, that is a very nice looking mold for hard cheese, where did you get it.
Title: Re: Chevre Moulds - Size/Shape/Holes Recommendations
Post by: Vaudevilleorange on July 16, 2011, 02:48:52 PM
I decided to run an experiment! I used 3 different kinds of molds.

The hard cheese mold (which I bought here http://grains-n-beans.com/cart/cheese-making-cheese-molds-baskets-c-26_53.html (http://grains-n-beans.com/cart/cheese-making-cheese-molds-baskets-c-26_53.html) greatest store EVER)

A quart sized plastic tub I poked sparse holes in with a hot nail

and

A pint sized plastic tub I poked sparse holes in with a hot nail

(I used different sizes to see if the mass of the curd effected the drain-ablity)

They are draining right now! I will post pictures of the results.

PS. I have no idea if that pH is normal, that is what my meter read...I might have it calibrated wrong??
Title: Re: Chevre Moulds - Size/Shape/Holes Recommendations
Post by: Vaudevilleorange on July 16, 2011, 09:47:44 PM
Hurray It worked! It turned out creamy and wonderful. The only difference between the molds was that the hard cheese mold was done in 1/2 the time - the others are still draining...though they do seem to be creamier...(http://C:%5CUsers%5CLizilla%5CDocuments%5CDesktop%5CCHEESE.jpg)
Title: Re: Chevre Moulds - Size/Shape/Holes Recommendations
Post by: george13 on July 16, 2011, 10:28:31 PM
Looks great, congrats and bon appetit!