CheeseForum.org » Forum
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
This topic
This board
Entire forum
Home
Help
Login
Register
CheeseForum.org » Forum
»
GENERAL CHEESE MAKING BOARDS (Specific Cheese Making in Boards above)
»
EQUIPMENT - Making Cheese
»
My first curd cutter
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: My first curd cutter (Read 1107 times)
Drew
Guest
My first curd cutter
«
on:
January 27, 2019, 04:46:35 AM »
So here is my first attempt at making a curd cutter. I used Bob’s layout from here:
http://blog.cheesemaking.com/bobs-homemade-curd-cutter-part-2/
The only difference is I welded a crosspiece to add a little more structure to it. Other than that it is pretty much the same. The spacing is 1/2 inch. Please tell me what you think.
Logged
TravisNTexas
Mature Cheese
Location: Near Dallas
Posts: 117
Cheeses: 6
Sweet dreams are made of cheese...
Re: My first curd cutter
«
Reply #1 on:
January 27, 2019, 02:54:51 PM »
Nice job Drew. AC4U. I think the cross piece is necessary to keep the main rod from bowing so you can keep it a thin gauge of steel. I plan on the same thing basically, but I bought some very fine stainless wire to try instead of fishing line.
Logged
-Travis
Print
Pages: [
1
]
Go Up
« previous
next »
CheeseForum.org » Forum
»
GENERAL CHEESE MAKING BOARDS (Specific Cheese Making in Boards above)
»
EQUIPMENT - Making Cheese
»
My first curd cutter